Most small toys are assembled: a body, four legs, four pins, and a set of instructions. A print-in-place articulated toy skips all of that. The legs come off the plate already attached, and the gap between the leg and the body is a design decision rather than leftover space.
What print-in-place actually means
The printer lays down the body and the leg in the same operation, with a small air gap between them. The gap is printed wide enough that the two parts do not fuse, and narrow enough that they stay linked instead of separating. When the plate cools, the leg moves — but it cannot come off, because it was never a separate object.
That is the whole trick, and it is unforgiving. A gap a fraction too small fuses the joint into a solid lump. A gap slightly too large lets the leg detach on the first flex. There is no way to fix it afterwards, which is why print-in-place models are usually tested across several printers before they ship.
Why a 1.5 inch frog is the right test case
Small parts shrink. At the size of the pocket frog — 1.57 in wide, 1.48 in long, 0.46 in tall — the joints are only a few millimetres across, and any drift in the gap shows up immediately as a leg that either sticks or flops.
The frog is printed at 0.12 mm fine layers rather than the usual 0.2 mm. Finer layers mean less vertical stepping on each joint face, which makes the movement smoother and the surface noticeably less ribbed. It also roughly doubles the print time for the same volume: this piece takes about 30 minutes rather than 15, for a 4 g object.
What articulation buys you
A jointed object can hold a pose. Flat on the desk, squatting with the hind legs folded, or rolled onto its back — each is a shape you can leave and come back to. A rigid figurine holds one shape forever, which is why rigid small objects tend to end up in a drawer.
The legs also move freely and settle wherever gravity leaves them, which is a different feel from a toy with detents. Nothing clicks into place. If you want a toy that holds a specific pose firmly, this is not it; if you want one that you can fiddle with and set down, it is.
The two-tone build
The frog is a single two-tone build: blue-green body with warm orange patches, toe tips and eye rings. There is no colour choice, because the colour is not applied afterwards — it comes from printing different sections in different filaments on the same plate.
That also means the orange is not paint and will not wear off, but it does mean the tone is fixed at the moment of printing rather than selected at checkout.
Cleaning up a print-in-place piece
Strings can appear inside the joint gaps, especially on small models. They are thin filament wisps, not structural, and they pull out with tweezers or a fingernail. Doing it once when the toy arrives is usually enough; the joints do not re-string afterwards.
For the broader material questions, our notes on whether 3D-printed pieces are safe for food, pets and kids cover what PLA is and is not good for.
Made to order in our workshop
The frog is printed in PLA at 0.12 mm layers, one frog per order, and shipped in a padded mailer — it weighs 4 g, so there is nothing to protect it from except the envelope itself. Production runs one to three business days. See the articulated pocket frog or the rest of the shop.