A figurine skirt is usually a cone: one smooth silhouette, one flat colour, nothing to look at from the side. The ballet girl on our shelf is built the other way round — the skirt is a stack of concentric rings, each slightly wider than the ring above it.
Why rings instead of a cone
A stack of rings gives you a stepped, flared edge that catches light at every step. From straight on it reads as a skirt. From the side it reads as something made, with a visible structure rather than a smooth mass. That is the difference between a figurine that looks molded and one that looks printed — and it is the reason the piece is worth looking at up close rather than only from across a room.
The dancer sits on top: round face, closed eyes, a bow across the hair, both arms held out to the sides. One print from hem to bow, no separate parts.
The numbers behind it
Size — 2.65 in tall, 3.44 in across the skirt (67 x 87 mm). The base is slightly wider than the skirt itself, which is what stops it tipping when a shelf gets knocked.
Weight — 57 g at 0.2 mm layers, 2 walls, 15% grid infill. That is heavy enough to feel solid in the hand without being a paperweight.
Print time — about 2 h 13 m on a Bambu Lab A1. Not fast, and not intended to be: the ring stack means the nozzle changes direction at every step, which is where the time goes.
Why 0.2 mm layers, not 0.12
The pocket frog is printed at 0.12 mm because its joints are only a few millimetres across and need every bit of resolution. The figurine is the opposite case: at 2.65 inches tall with a stack of wide rings, a finer layer would add several hours of print time and buy almost nothing visible.
What finer layers change is the surface, and on a piece this size the surface is already busy. The ring steps do the work that a smoother finish would do on a plain object, so 0.2 mm is the right trade: same silhouette, half the machine time.
Where the supports go, and what is left behind
The arms are held out horizontally, which means they need support underneath. Tree supports are used and removed by hand, and a faint scar can remain under one arm. It sits on the underside, so it is invisible on a shelf and only findable if you pick the piece up and turn it over.
This is the honest trade in 3D-printed decor: the geometry that makes a silhouette interesting is usually the geometry that needs support, and support removal leaves a mark somewhere. The question is whether the mark is on the front or underneath.
Material and where it should not live
PLA, matte. It is indoor decor and it is not heat-tolerant: keep it off radiators, out of direct summer sun, and away from open flame. A dresser, a shelf, a bedside table are all fine.
If you are new to the material, our explainer on what to look for in 3D-printed decor covers layer lines, weight and finish — the three things that decide whether a piece looks intentional or cheap.
Made to order in our workshop
Each figurine is printed in matte PLA in seven colors and packed in recycled cardboard. Layer lines follow the ring steps on the skirt and are visible up close; there is no paint and no coating, so what you see is the material itself. See the twirling ballet girl figurine for the current colorways.