Ring Base Headphone Stand

$10.99

A two-tone headphone stand in a single print: gray oval-ring base and two uprights, olive green cradle arms on top. Five parts, press fit, no glue. 8.49 × 8.74 in footprint, about 8.3 in tall.

  • Arrives intact or we replace it free
  • Tracked shipping to your door
  • Secure PayPal checkout
Your order is covered. If anything arrives damaged or isn’t what you expected, message us within 7 days with a photo and we’ll make it right — a free replacement or a full refund, your choice. Read our shipping & returns policy.

Description

Headphones left on a desk get sat on, knocked off, and buried under whatever else lands there. This stand lifts them clear and holds them by the headband instead of a surface.

The base is a flat oval ring rather than a solid plate — it takes up about the same desk area as the headphones themselves, but the open middle keeps the footprint light and the ring shape makes it stable enough that a full-size headset will not tip it.

Two uprights rise from the ring and lean inward toward a pair of cradle arms, so the headband rests on one arched contact instead of a wide bar pressing into the padding.

Two colours, printed in one piece

  • Gray body, olive cradle — the base and uprights print in matte gray PLA, the cradle arms in olive green PLA Matte. The colour change happens at the layer line during printing, not by painting afterwards.
  • Five parts, press fit — one base ring, two uprights, two cradle arms. The uprights slot into the ring and the arms sit on top; no glue, no screws.
  • Ring base — 8.49 × 8.74 in at the widest point, low and wide, so the stand stays put when you lift a headset off it.
  • Single contact point — the arms meet at the crown, which spreads the load across the headband rather than squeezing it.

Specs

Material PLA, matte (gray body, olive green cradle arms)
Base footprint 8.49 × 8.74 in (21.6 × 22.2 cm)
Height approx. 8.3 in (21 cm)
Weight 2.78 oz (79 g)
Layer height 0.2 mm
Parts 5 printed parts per stand
Print time about 3 hours across two plates
Printer Bambu Lab A1, 0.4 mm nozzle

Notes

Rods and arms fit by hand; they seat fully with light pressure. Layer lines and minor variation between printed parts are normal for FDM printing. Wipe with a dry or slightly damp cloth. Do not leave it in a hot car — PLA softens around 60 °C.

Additional information

Weight 0.17 kg
Dimensions 8.49 × 8.74 × 8.3 cm
Color

Gray / Olive Green

Reviews

There are no reviews yet.

Be the first to review “Ring Base Headphone Stand”

Your email address will not be published. Required fields are marked *