Self-Draining Soap Dish

$8.99

A soap dish that gets the water away from the bar instead of letting it sit in its own runoff. Angled ribs under the soap, perforated slots around the rim, and a lower tray that collects what drains. Printed in PETG, 5.35 × 4.25 × 1.12 in, seven colors.

  • Arrives intact or we replace it free
  • Tracked shipping to your door
  • Secure PayPal checkout
Your order is covered. If anything arrives damaged or isn’t what you expected, message us within 7 days with a photo and we’ll make it right — a free replacement or a full refund, your choice. Read our shipping & returns policy.

Description

Most soap dishes do the same thing: the bar sits flat, water collects underneath, and by the third day the bottom of the soap is soft and stuck to the tray. This one is built around that problem.

The deck is a set of angled ribs rather than a solid plate, and the rim is cut with rectangular slots. Water leaves the bar immediately, runs down the ribs and drops into the tray below. A small tab at one end lets you tip the collected water out without lifting the whole dish.

Why it works

  • Angled ribs under the bar — the soap rests on raised edges, not a flat surface, so air reaches the underside and the bar stays firm between uses.
  • Perforated rim — slots along the wall give water a way out sideways instead of pooling in the corners.
  • Lower collection tray — runoff gathers beneath the ribbed deck; the tab at the side lets you pour it off in one motion.
  • Stays where you put it — no wall mounting, no drilling, no bracket. It sits flat on the sink, a shelf or the shower ledge.

Printed in PETG, not PLA

Bathrooms are the worst place for PLA. Warm water and constant wet-dry cycling soften it, and toothpaste residue leaves a chalky surface within weeks. This dish is printed in PETG, which keeps its shape in a wet environment and does not get brittle over a season of daily use.

Specs

Material PETG, matte finish, 0.2 mm layers
Size 5.35 × 4.25 × 1.12 in (13.6 × 10.8 × 2.85 cm)
Weight 2.08 oz (59 g)
Colors Black / White / Red / Orange / Yellow / Green / Blue
Printer Bambu Lab A1, 0.4 mm nozzle

Care

Tip the lower tray out and rinse it under warm water; the ribs wipe clean with a fingertip. Not dishwasher safe — a heated drying cycle can distort a printed part. Hand wash only.

Every dish is printed to order. Fine layer lines and the occasional small surface mark are part of FDM printing, not a defect.

Additional information

Weight 0.13 kg
Dimensions 5.35 × 4.25 × 1.12 cm
Color

Black, White, Red, Orange, Yellow, Green, Blue

Reviews

There are no reviews yet.

Be the first to review “Self-Draining Soap Dish”

Your email address will not be published. Required fields are marked *