Posted on

Five Parts, One Coil: How a Spring Neck Gecko Is Assembled

A toy with a moving neck is usually a toy with a hinge, and a hinge has a failure mode: it either loosens until the head droops or snaps off entirely. This one uses a thread instead, which behaves differently in both directions.

What the coil actually is

Between the head and the body sits a printed helical coil — a real thread, printed as two separate pieces. The head screws onto it. When the head is seated, the coil supports it, and a tap on the snout makes the head bob and settle rather than swing.

The difference from a hinge is that the coil has spring in it. A hinge returns nothing; a coil returns a little. That is what makes the movement read as a toy rather than as a broken part.

The five parts

Body with feet and tail, head, mouth, two eyes, and two coil pieces. Everything screws or slots together and nothing is glued, which means the piece can be taken apart and reassembled for a different pose without damaging it. Assembly is about ten seconds: screw the head onto the coil until it seats, then set the piece on its feet.

The body is hollow at the base, so it sits flat rather than rocking. That is the difference between a toy that stands on a desk and one that has to be propped against something.

The numbers

Size — 4.81 in long, 2.14 in tall standing, 3.47 in across the feet (122 x 54 x 88 mm).

Weight — 55 g across the five parts, at 0.2 mm layers, 3 walls, 10% gyroid infill. Three walls rather than two, because the thread takes load.

Print time — about 4 h 10 m for the full set of plates. This is the slowest piece in our current range, and most of it is the coil: a helix at 0.2 mm layers is a long, uninterrupted spiral of small moves.

Why the material changes halfway

The coloured parts are PLA. The coil is PETG. That is not a cost decision — it is a function decision. PLA is stiff and brittle, which is wrong for a spring: a PLA coil takes a set and stops returning. PETG is more elastic, so it behaves like a spring instead of like a bent wire.

This is the one place in the current range where two materials appear in one object, and it is the reason the neck works.

Shipping something with a loose head

The gecko ships assembled, which creates a packing problem: a head held on by a printed coil is not a rigid object, and a mailer that treats it as rigid will arrive with the head somewhere else in the box. Ours goes out with the head seated and the piece braced so it does not rotate in transit; if yours arrives with the head turned to one side, nothing is broken — screw it back down.

That is worth knowing before you assume a delivery is damaged. The one genuinely fragile moment is the thread itself, not the assembly.

The edge you should know about

Where the coil meets the head, the thread edges are sharp. Run a fingertip along the seam once when it arrives and it is fine — it is a moulding artefact of a fine helix, not a defect. It is worth mentioning because a parent buying this for a child will find it, and it is better to know in advance than to find it by surprise.

Four colourways, same model

Multicolor ships as blue head, red mouth, green coil, yellow body. Blue, Green and Yellow are solid builds of the same model — head, mouth, coil and body all print in that one colour. Same size, same five parts, same assembly method.

That is a deliberate choice rather than a shortcut: a solid build reads as a sculpture, a multicolour build reads as a toy. Both are the same object.

Made to order in our workshop

Made to order in these four colourways and shipped assembled. PLA for the coloured parts, PETG for the coil, production one to three business days. See the spring neck gecko or the shop.