Description
A toy that is mostly mouth
The head is oversized and open in a scream, with a red tongue and a pair of white eyes on top. Between the head and the body sits a genuine printed coil – a helical thread you screw the head onto, which is what lets the neck bend and bob instead of snapping.
Four colorways
Multicolor ships exactly as shown above: blue head, red mouth, green coil, yellow body. Blue, Green and Yellow are solid builds of the same model – head, mouth, coil and body all print in that one color. Same size, same five parts, same assembly.
Numbers
- Size – 4.81 in long, 2.14 in tall standing, 3.47 in across the feet (122 x 54 x 88 mm).
- Weight – 55 g across five parts. 0.2 mm layers, 3 walls, 10% gyroid infill.
- Print time – about 4 h 10 m for the full set of plates.
- Parts – body with feet and tail, head, mouth, two eyes, and two coil pieces. Everything screws or slots together; no glue needed.
- Material – PLA for the colored parts plus a PETG coil. Indoor use, away from heat.
Assembly
Screw the head onto the coil until it seats, then set the piece on its feet. It takes about ten seconds and can be taken apart again for a different pose. The body is hollow at the base, so it sits flat rather than rocking.
How it ships
Made to order in this multi-color build and shipped assembled. Thread edges are sharp where the coil meets the head; run a fingertip along it once and it is fine.









Reviews
There are no reviews yet.