Description
A desk cup with a face
The front wall is built up into a cat face – bow on the left ear, whiskers, nose and two eyes – while the two ears rise above the rim to form high edges. Inside, dividers split the cup into three sections, so pens, scissors and a roll of tape stop mixing into one pile.
Numbers
- Size – 5.01 in wide, 4.51 in deep, 2.95 in tall (127 x 115 x 75 mm).
- Weight – 143 g. 0.2 mm layers, 2 walls, 10% gyroid infill.
- Print time – about 3 h 52 m on a Bambu Lab A1.
- Supports – tree supports under the ears and the face relief, removed by hand.
- Material – PLA, matte. Indoor use only; PLA softens in a hot car.
Base and balance
The oval foot plate is wider than the cup body, so a full load of pens does not tip it forward. The face relief is molded into the wall rather than glued on, so there are no seams to catch dust.
How it ships
Made to order in seven colors, packed in recycled cardboard. Layer lines are visible on the flat surfaces and along the bow; no paint or coating.









Reviews
There are no reviews yet.